Welcome, Guest
Username: Password: Remember me

TOPIC: ABI 3200 Tailwheel installation

ABI 3200 Tailwheel installation 4 months 3 weeks ago #796

  • keithuhls
  • keithuhls's Avatar
  • OFFLINE
  • New Member
  • Posts: 2
  • Karma: 0
We got the tail wheel but the bolt is too large for the exiting hole in the tail spring. Do I purchase a new tail spring or do I drill the correct hole in the tail spring.
The administrator has disabled public write access.

ABI 3200 Tailwheel installation 4 months 2 weeks ago #797

I'd call ABI to verify, but I think there is usually a bushing that is used on the bolt where it passes through the tailwheel. Then the correct diameter bolt fits the tail spring properly.
Bill
The administrator has disabled public write access.
Time to create page: 0.212 seconds
Powered by Kunena Forum
Cron Job Starts